AOC LM560/s manual Controls and Connectors Video Cable, Connecting Cables AC Power Cord Sub Cable

Page 7

CONTROLS AND CONNECTORS

VIDEO CABLE

Connecting the D-Sub Cable:Connect one end of the 15-pin D-Sub cable

to the back of the monitor and connect the other end to the computers D Sub port.

Connecting the Power Cord:Connect the power cord into your LCD

monitors power input socket, and then plug the other end into a 3-pin A power outlet. The power cord may be connected to either a wall power outle or the power outlet socket on your PC, depending on the type of power cord supplied with your LCD monitor.

Caution: If the AC outlet is not grounded (with three holes), install the p grounding adapter (not supplied).

Figure 2 Connecting Cables

1.AC Power Cord

2.D-Sub Cable

5

Image 7

Contents Page Table of Contents FCC Class B Radio Frequency Interference Statement Safety Lamp Disposal Precautions Checking the Contents of the Package Before YOU Operate the Monitor FeaturesSpecial Notes on LCD Monitors Power Cord Installation Instructions Swivel BasePower Source Connecting Cables AC Power Cord Sub Cable Controls and Connectors Video CableAdjusting the Viewing Angle External Controls General InstructionsMenu / Enter Front Panel Control ∙ Power Button∙ Power Indicator ∙ Auto Adjust button / ExitOSD Message HOW to Adjust a SettingEeprom Adjusting the PictureOSD Using the Right Power Cord Plug & Play DDC2B FeaturePlug and Play Technical Support FAQ Input not Supported Error Message & Possible Solution Cable not ConnectedVesa DDC2B TM Appendix SpecificationsCE, FCC, TCO99 MenuStandard Resolution Horizontal Vertical Frequency Preset Display ModesRXD Connector PIN AssignmentPIN no Description PI N no VGA-CON