MRV Communications Official Installation Manual for the TereScope Network Card

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l

2.Back

All models of the TereScope are SNMP manageable. SNMP monitoring can be performed using MRV’s MegaVision SNMP management application.

A. TS700/155 (Standard Model)

The TS700 supports Fast Ethernet, OC3, STM1, E3, and T3 protocols in the 34- 155 Mbps range. A special type of TS700 can be ordered that can be used for Open Protocol applications which ensures complete transparency (including all data in the range of 1-155 Mbps.) In this type, less than 2 dB of the budget is lost.

If you need to install the SNMP card into the TereScope, after installing the card and before closing the back panel, carefully punch out this piece of metal.

NOT IN	AIR RX	F/O RX
USE	FLAG	FLAG
MANAGEMENT	SYNC	SYNC

OPTICAL POWER

FIBER OPTIC

POWER

USE COPPER CONDUCTORS ONLY

VOLT.LOW +/~ G -/~

HIGH L G N VOLT.

TORQUE VALUE 7 Lb-Inch

DIP Switch Toggles 6,7,8 positions are not used.

Switch	Mode of		Ip		Data Rate
			Address
Position
	1	2	3	Fast	ATM	E3	T3
				Ethernet	OC3
UP	Alignment	Local		-	4,5	4	5
		Loopback
DOWN	Normal	Normal	Default IP	4,5	-	5	4

MRV

TX RX

TELESCOPE

Main Data:

SC or ST

Connector

1762310-SC

Figure 1.2a: TS700/155 Standard Model Panel Schematic

Figure 1.2b: Rear View of TS700/155

3