M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
Figure 2.1: Optimal Mounting
TereScope at edge of roof so that heat rising from roof surface does not affect beam
Beam path more than 4.5 m (15 ft) above surface to avoid traffic and rising heat.
Figure 2.2: Acceptable Mounting
Figure 2.3 shows an unrecommended TereScope link location because of interference by IR. Notice that the TereScopes are mounted far from the rooftop edges or are too close to the ground.
TereScope not at edge of roof.
Less than 4.5 m (15 ft) between beam path and
TereScope not at edge of roof.
Beam path passes too close to ground. Heat rising causes scintillation. Allow 4.5 m (15 ft) between ground and beam path.
Figure 2.3: Unrecommended Mounting
19
