M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
Note: If the only option to mount the TereScope is at points 5, 6 or 7, it has to be mounted at least 2 m above the rooftop to avoid roof scintillations and people crossing the link beam (If possible, avoid placing the TereScope on a mast).
3.Avoid surfaces with high reflectivity (e.g., white walls) behind the TereScope so as to reduce interference with the optical signal.
4.Get customer approval for the exact positions where the TereScopes will be mounted. Using paint, mark these positions.
5.Note the height that each TereScope will be above or aside the rooftop.
6.Identify the floor or wall type and dimensions of the location at which it is planned to mount the TereScope.
7.For each TereScope head, select one of the following mounting options2 and record it.
a.Parapet/Ledge Mounting (Figure 2.6) – This is a standard mounting option that uses only the Plate (JMP).
b.Wall Mounting (Fig. 2.8) – This is a standard mounting option that uses the Plate (JMP) as well as the two Brackets (JMB).
c.Floor Pedestal Mounting (Figure 2.7) – This is a
d.Wall Pedestal Mounting (Figure 2.9) – This is a
e.Extended Wall Mounting (Figure 2.10) – This is a
f.Angle Bracket Mounting (Figure 2.11) – This is a
Figure 2.6: Parapet/Ledge Mounting (using JMP only) Figure 2.7: Floor Pedestal Mounting (using JMP and MO15C)
2For more information on these mounting options, refer to TereScope Installation Guide (Publication No. 46366).
21
