MRV Communications TS800/155, TS700/155, TS700/100 Standards Compliance, FCC Notice, CE Mark

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l

Standards

Standards Compliance

UL 1950; CSA 22.2 No 950; FCC Part 15 Class B; CE-89/336/EEC, 73/23/EEC

FCC Notice

WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions in the manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct for the interference at the user’s own expense.

The user is cautioned that changes and modifications made to the equipment without approval of the manufacturer could void the user’s authority to operate this equipment.

It is suggested that the user use only shielded and grounded cables when appropriate to ensure compliance with FCC Rules.

CE Mark

The CE mark symbolizes compliance with the EMC directive of the European Community. Such marking is indicative that the specified equipment meets or exceeds the following technical standards:

•EN 55022 - Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equipment

•EN 50081-1- Electromagnetic compatibility - of Radio Interference Characteristics of Information Technology Equipment Generic Emission standard Part 1 – Residential commercial and light industry environment

•EN 50082-1 - Electromagnetic compatibility -- Generic immunity standard Part 1: Residential, commercial and light industry environment

•EN61000-4-2 (previously IEC 1000-4-2) - Electromagnetic compatibility for industrial- process measurement and control equipment Part 4: Section 2 - Electrostatic discharge requirements

•EN61000-4-3 (previously IEC 1000-4-3) - Electromagnetic compatibility for industrial- process measurement and control equipment Part 4: Section 3 - Radiated electromagnetic field requirements

•EN61000-4-4 (previously IEC 1000-4-4) - Electromagnetic compatibility for industrial- process measurement and control equipment Part 4: Section 4 - Electrical fast transient/burst requirements

•EN61000-4-5 - Electromagnetic compatibility for industrial-process measurement and control equipment

Part 4: Section 5 – Surge Immunity requirements

•EN61000-4-6 - Electromagnetic compatibility for industrial-process measurement and control equipment

Part 4: Section 6 – Immunity to conducted disturbances induces by radio frequency fields

•EN61000-4-8- Electromagnetic compatibility for industrial-process measurement and control equipment

Part 4: Section 8– Power frequency magnetic field immunity requirements

•EN61000-4-11 – Electromagnetic compatibility for industrial-process measurement and control equipment Part 4: Section 11 – Voltage dips short interruptions and voltage variations immunity requirements

•EN61000-3-2 – Harmonic standard

•EN61000-3-3 – Voltage Fluctuation and Flicker standard

•CISPR 22 - Radiated and Line-conducted Class B

•EN 60950 - ITE Safety

i