M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
APPENDIXE | TereScopes Bench Test Procedure |
Introduction
All TS Products are bench tested indoors prior to outdoor installation to ensure that the system is fully functional.
The bench test is a simple procedure whereby a link pair is aligned on the table and activated to simulate a channel of communication (see fig.1).
2 Points to Remember
1.Since the link distance during the bench test is very short (i.e. the devices activated are very close), the receivers will go into saturation unless the signal is attenuated. (NOTE: In the 700/G, deep into saturation the DVM reading may actually drop back down, giving the false impression that the link is misaligned. It is therefore vital to place the attenuator in the link path before optimizing alignment.)
To avert entering saturation, the transmit signal must be physically attenuated.
We recommend the simple procedure of inserting a piece of paper or the like into the beam path, or concealing a portion of the beam with an opaque
Make sure to attenuate the signal enough so that the receiver’s optical power meter value falls below the saturation estimate of the device. See table below for saturation estimate.
2.An additional derivative of the short link distance is the presence of reflections.
The signal will reflect off the front window of the receiver back at the transmitting device and may be mistaken as part of the opposite transmission.
This interference is commonly called “cross talk”.
To avoid cross talk during the bench test, it is advisable to check whether interfering reflections exist by shutting off power to one device and verifying that the optical power meter reading in the other (active) device is zero.
This should be repeated for the opposite device. Alternatively, a practical setup for bench testing the 4” series (models B, C and D) and Light series (models A and C2) is presented in Figure 1; the bench test setup for the 10” series (models E and F) is presented in Figures 2a,2b.
In the 4”/Light setup, a thin physical barrier, such as a piece of cardboard, is used as a wall to divide between the beam paths, thus ensuring that no cross talk occurs.
In the 10” setup, the two devices are not centrally aligned; instead, only one corner of each device faces the opposite device. This
55
