Fujitsu N800 manual Drives are reported as “dead”, Added drive reported defective

Troubleshooting and tips Drives are reported as “dead”

7.10Drives are reported as “dead”

This error message may occur when the server has a disk array controller.

SCSI cabling incorrect

ÊMake sure that the SCSI cabling and the SCSI channel assignment still correspond to the original state.

The configuration of the disk array controller is incorrect

ÊCheck and correct the settings for the drives with the DAC utility DACCF or EzAssist.

Refer to the documentation for the disk array controller for further information.

7.11Added drive reported defective

This error message may occur when the server has a disk array controller.

Disk array controller is not configured for this hard disk drive

The drive was probably installed with the system switched off.

ÊReconfigure the disk array controller for the hard disk drive with the DAC utility DACCF or EzAssist. Refer to the documentation for the disk array controller for further information.

or

ÊReinstall the drive while the system is up and running.

If the hard disk drive continues to be shown as defective, replace it (see section “Replacing SCSI hard disk drives” on page 91).

7.12Error messages on the screen

The meaning of the error messages is contained in the manual on BIOS Setup and in the documentation on the boards and programs used.

U41243-J-Z156-1-76 79