Preparation for use and operation | Cleaning the server |
Password Clear:
This switch controls whether the current password is retained or cleared when the system is reset.
If you want to change the current password, proceed as follows:
ÊFollow the procedure described in the section “Changing the switch settings”.
ÊSet DIP switch 3 (see table 2 on page 38) to ON.
ÊSwitch the system on. Wait for POST to complete. This clears the current password.
ÊShut down the system, turn the server off and disconnect it from the line voltage.
ÊReset DIP switch 3 (see table 2 on page 38) to OFF.
ÊReconnect all peripheral devices, reconnect the server to the line voltage, and switch the server on.
ÊRun BIOS Setup to enter a new password (see section “BIOS Setup” on page 47).
4.5Cleaning the server
VCAUTION!
Switch off the server and pull the power plugs from the grounded insulated sockets.
Only authorized service personnel are allowed to clean inside the server.
Do not use any cleaning agents that contain abrasives or may corrode plastic.
Ensure that no liquid enters the system and that the ventilation areas of the server and monitor remain clear.
You can use a disinfection cloth to clean the outside of the keyboard and the mouse.
Wipe the server and monitor casing with a dry cloth. If particularly dirty, use a cloth that has been moistened in mild domestic detergent and then carefully wrung out.
43 |
