5Configuration software and utilities

This chapter describes the Power-ON Self-Test (POST) and the configuration software.

5.1Short cuts using a key combinations

Use the numeric pad on the keyboard to enter numbers and symbols.

 

Key combinations

 

 

 

Clear memory and reload the

+

+

operating system, i.e. system reset

 

 

 

 

 

Save system immediately

+

+hotkey (set your hot-key

 

combination with BIOS Setup.)

 

 

 

Call BIOS Setup during POST

 

 

 

 

 

Table 3: Key combinations

 

 

5.2Power-ON Self-Test (POST)

Every time you turn on the system, the POST starts. It checks the boards, processors, memory, keyboard and most installed devices. During the memory test, POST displays the amount of memory it is able to access and test. The length of time needed to test memory depends on the amount of memory installed. POST is stored in flash memory.

ÊTurn on your monitor and the system. POST starts up after a few seconds.

After the memory test, the following screen prompts and messages are displayed:

ib

k

nr

U41243-J-Z156-1-76

45

Page 53
Image 53
Fujitsu N800 manual Configuration software and utilities, Short cuts using a key combinations, Power-ON Self-Test Post