Fujitsu N800 manual Controls and indicators, Drive error

Controls and indicators Preparation for use and operation

When the system is switched off, the system is

ON/OFF button: switched on by pressing the ON/Off button. When the system is operating, pressing the

ON/OFF button will switch off the system.

IThe ON/OFF button does not disconnect the server from the line voltage. To disconnect from the line voltage, remove the power plug from the power outlet.

Reset button:

Power-on indicator:

!	Power failure
	indicator:

!Fan failure indicator:

! Drive error:

Pressing the Reset button reboots the system. The Power-ON Self-Test (POST) is started.

Lights up green when the server is switched on and DC power is present in the server.

Does not light up if the server is switched off or if the power supply has been interrupted.

Lights up yellow if DC power is not present in the server.

Lights up yellow if a fan has failed.

Lights up yellow if an error status exists for one or more hard disks in the drive cage.

Blinks yellow if a hard disk reset is being performed.

LCD display field:

Information about the processor type and error codes are displayed on the LCD display field (see the section “Error messages on the LCD display” on page 80).

NMI button: Pressing on the NMI button causes a non-maskable interrupt. This button is located behind the front panel to prevent inadvertent activation. It must be pressed with a narrow tool (not supplied).

34 U41243-J-Z156-1-76