Fujitsu N800 manual RemoteView storage medium, Installing a memory module

RemoteView storage medium System expansions

8.7.3Installing a memory module

ÊPopulate the module you have just removed with the additional DIMMs (see the section “Installing DIMMs” on page 110).

If you are installing an additional module, this must be populated with the DIMMs before installation.

I Install the module with the component side down.

ÊOpen the insert/eject levers of the module (by rotating them outward 90°) and slide the module into the slot guides of the empty slot until the levers engage with the flanges in front of the guides.

ÊSimultaneously rotate the levers inward until they are flush with the edge of the module.

ÊMount the memory module cover (four screws) and the front bezel).

ÊUse BIOS Setup to configure the system and if necessary specify the correct, expanded memory attributes.

8.8RemoteView storage medium

For use RemoteView, the remote test and diagnosis system, on the N800 servers an optional RemoteView IDE storage medium (chipDISK for RemoteView) is available.

The IDE storage medium is either pre-installed in the delivered server or is included in the delivery unit as a separate component. This depends of the way RemoteView has been ordered. The installation of the ChipDISK should only be executed by service technicians.

Usually the IDE storage medium is shipped with the RemoteView/Diagnosis System pre-installed.

IA supplementary order of a ChipDISK do not contains the pre-installed RemoteView/Diagnosis System.

114 U41243-J-Z156-1-76