Fujitsu N800 Features, Processors and Memory, Hard disk system, Externally accessible drives

Features Introduction

1.1Features

Processors and Memory

The server can accommodate up to eight Intel Pentium III Xeon™processors with a clock frequency of 700 MHz or 900 MHz. 1 MB and 2 MB second level cache are available.

The 700 MHz or 900 MHz processors are mounted on „Palmetto mezzanine“ carrier boards.

VCAUTION!

In order to prevent a damage of the processors, pay attention that the processors are mounted on the corresponding carrier boards only.

Up to 32 GB Ram memory with ECC SDRAM technology are available.

Hard disk system

The hard disk system consists of four hard disk slide-in modules. Each module can accommodate a SCSI hard disk drive with a SCA (Single Connector Attachment) interface and a maximum height of 1 inch. The hard disk drives are accessible from the front of the system and connect to two LVDS/SCSI backplanes. The connection to the SCSI backplane is implemented via the SCA interface (no cable required) and allows the hard disk slide-in modules to be attached or detached easily (hot-plug). As part of the hot-plug implementation, a hard disk slide-in module with integrated heat dissipation is required. The drives are fastened to the slide-in module, which snaps into the chassis with a locking mechanism.

Externally accessible drives

A3.5-inch floppy disk drive and an IDE-CD-ROM or DVD drive with 0,5-inch height are available. Additionally a 5,25-inch SCSI tape drive for backup can also be used.

The externally accessible drives are accessed from the front of the system.

The floppy disk drive, CD-ROM respectively DVD drive and backup drive are mounted in a common cage. The accessible drives can not be replaced during operation.

2 U41243-J-Z156-1-76