AOC LM914 user manual Technical Support FAQ

Page 17

LM914

TECHNICAL SUPPORT (FAQ)

Problem & Question

Possible Solution

Power LED is not on

*Check if the Power Switch is in the ON

 

position

 

*Power Cord should be connected

No Plug & Play

*Check if the PC system is Plug & Play

 

compatible

 

*Check if the Video Card is Plug & Play

 

compatible

 

*Check if the D-15 plug pin of Video

 

Cable is bent

 

*Make sure the AOC Monitor Drivers are

 

installed

 

(AOC Monitor Drivers are available at:

 

www.aocmonitor.com)

Picture is fuzzy

*Adjust the Contrast and Brightness

 

Controls.

Picture bounces or a wave

*Move electrical devices that may cause

pattern is present in the picture

electrical interference.

The power LED is ON (orange)

*Computer Power Switch should be in

but there’s no video or no

the ON position.

picture.

*Computer Video Card should be snugly

 

seated in its slot

 

*Make sure monitor’s video cable is

 

properly connected to the computer.

 

*Inspect monitor’s video cable and make

 

sure none of the pins are bent.

 

*Make sure computer is operational by

 

hitting the CAPS LOCK key on the

 

keyboard while observing the CAPS

 

LOCK LED. The LED should either

 

turn ON or OFF after hitting the CAPS

 

LOCK key.

Missing one of the primary

*Inspect the monitor’s video cable and

colors (RED, GREEN, or

make sure that none of the pins are

BLUE)

bent.

16

Image 17
Contents LCD Monitor LM914FCC Class B Radio Frequency Interference Statement Precautions PrecautionsLM914 Special Notes on LCD Monitors FeaturesChecking the Contents of the Package Powercord Installation InstructionsPower Source Swivel BasePreparing to Install the Cables Installations InstructionsCable Connections Installation InstructionsLM914 Attaching The Optional Wall Mount Arm not supplied Adjusting the Viewing AngleLM914 External Controls General InstructionsPower Indicator Auto Adjust button / ExitVolume Control Front Panel ControlOSD Message HOW to Adjust a SettingAdjusting the Picture Plug and Play Plug & Play DDC1/2B FeatureUsing the Right Power Cord Technical Support FAQ LM914 No Signal Error Message & Possible SolutionUnsupported Mode TRY Different Video Card Setting ResolutionLM914 For First Time Install HOW to Install the DRIVER-DISK INF & ICM FileAppendix SpecificationsUL, CSA, FCC, T ÜV/GS, CE VGA Factory Preset Timing TablePIN no Description PI N no Connector PIN AssignmentTmds Data