AOC LM914 user manual Plug and Play, Plug & Play DDC1/2B Feature, Using the Right Power Cord

Page 16

LM914

PLUG AND PLAY

Plug & Play DDC1/2B Feature

This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities. The communication channel is defined in two levels, DDC1 and DDC2B.

The DDC1 is a unidirectional data channel from the display to the host that continuously transmits EDID information. The DDC2B is a bidirectional data channel based on the I²C protocol. The host can request EDID information over the DDC2B channel.

THIS MONITOR WILL APPEAR TO BE NON-FUNCTIONAL IF THERE IS NO VIDEO INPUT SIGNAL. IN ORDER FOR THIS MONITOR TO OPERATE PROPERLY, THERE MUST BE A VIDEO INPUT SIGNAL.

This monitor meets the Green monitor standards as set by the Video Electronics Standards Association (VESA) and/or the United States Environmental Protection Agency (EPA) and The Swedish Confederation Employees (NUTEK). This feature is designed to conserve electrical energy by reducing power consumption when there is no video-input signal present. When there is no video input signal this monitor, following a time-out period, will automatically switch to an OFF mode. This reduces the monitor's internal power supply consumption. After the video input signal is restored, full power is restored and the display is automatically redrawn. The appearance is similar to a "Screen Saver" feature except the display is completely off. The display is restored by pressing a key on the keyboard, or clicking the mouse.

USING THE RIGHT POWER CORD :

The accessory power cord for the Northern American region is the wallet plug with NEMA 5-15 style and is UL listed and CSA labeled. The voltage rating for the power cord shall be 125 volts AC.

Supplied with units intended for connection to power outlet of personal computer: Please use a cord set consisting of a minimum No. 18 AWG, type SJT or SVT three conductors flexible cord. One end terminates with a grounding type attachment plug, rated 10A, 250V, CEE-22 male configuration. The other end terminates with a molded-on type connector body, rated 10A, 250V, having standard CEE-22 female configuration.

Please note that power supply cord needs to use VDE 0602, 0625, 0821 approval power cord in European counties.

15

Image 16
Contents LM914 LCD MonitorFCC Class B Radio Frequency Interference Statement Precautions PrecautionsLM914 Checking the Contents of the Package FeaturesSpecial Notes on LCD Monitors Installation Instructions PowercordPower Source Swivel BaseInstallations Instructions Preparing to Install the CablesInstallation Instructions Cable ConnectionsLM914 Adjusting the Viewing Angle Attaching The Optional Wall Mount Arm not suppliedLM914 General Instructions External ControlsAuto Adjust button / Exit Power IndicatorVolume Control Front Panel ControlHOW to Adjust a Setting OSD MessageAdjusting the Picture Using the Right Power Cord Plug & Play DDC1/2B FeaturePlug and Play Technical Support FAQ LM914 Error Message & Possible Solution No SignalUnsupported Mode TRY Different Video Card Setting ResolutionLM914 HOW to Install the DRIVER-DISK INF & ICM File For First Time InstallSpecifications AppendixUL, CSA, FCC, T ÜV/GS, CE Factory Preset Timing Table VGAConnector PIN Assignment PIN no Description PI N noTmds Data