AOC LM-700 user manual Adjusting the Viewing Angle, How to Install INF & ICM File

Page 10

Before You Operate the Monitor

LM-700

Adjusting the Viewing Angle

For optimal viewing, adjust the monitor's angle to your own preference.

•Hold the stand firmly when you change the monitor's angle.

•You can adjust the monitor's angle from -5° to 30°.

•Do not touch the LCD screen when you change the angle. It may cause damage or breakage.

•Be careful to avoid pinching your hand in the swivel base.

How to Install INF & ICM File

1.Insert the Windows 95/98/2000/ME/XP INF Driver Disk into your floppy drive.

2.Follow the Add New Hardware Wizard instructions on the screen.

3.If the wizard asks for the location of the driver file, select drive A and press Next.

LM-700	10	v3_123102

Image 10

Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautions Special Notes on LCD Monitors Using the Right Power CordGeneral Notes Package Contents Installing & Removing the Base General FeaturesBefore You Operate the Monitor Connecting the Wires Using the Power Cord Supplied Before You Operate the Monitor LM-700 Install An Optional Wall Mounting Arm Not supplied Adjusting the Viewing Angle How to Install INF & ICM FileOperating Instructions Front Panel ButtonsAdjusting the OSD Settings Plug & Play DDC1/2B Feature How to Optimize the DOS-modeDOS-mode Technical Support FAQ Problem Possible SolutionError Message Possible Solution Resolution Chart Resolution VerticalSpecifications AppendixOptimal Viewing Mode 1280 x 1024 x 75 Hz Factory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number Description