Using the Monitor, Attaching Wall Mounting Arm

Turn off your computer before performing the procedure below.

1.Connect the power cable to the AC port on the back of the monitor.

2.Connect one end of the 15-pin D-Sub cable to the back of the monitor and connect the other end to the computer's D-Sub port.

3.Turn on your monitor and computer.

If your monitor displays an image, installation is complete. If it does not display an image, see Troubleshooting.

Attaching Wall Mounting Arm

Preparing to Install An Optional Wall Mounting Arm

4. Using the Monitor

Setting the Optimal Resolution

The recommended resolution for this monitor is 1440 by 900. To setup the monitor to this resolution, follow the steps below.

1.Click START.

2.Click SETTINGS.

3.Click CONTROL PANEL.

4.Double click DISPLAY.

5.Click SETTINGS.

6.Set the resolution SLIDE-BARto 1440 by 900.

External Controls

Press the power button to turn the monitor on or off. The other control knobs are located at front panel of the monitor (See Figure ). By changing these settings, the picture can be adjusted to your personal preferences.

*The power cord should be connected.

*Press the power button to turn on the monitor. The power indicator will light up.