AMCC 9690SA manual Operating System Requirements

Page 10

Chapter 1. Getting Started

Operating System Requirements

„Windows XP, Windows Server 2003 (32-bit and 64-bit x86), Windows Vista (32-bit and 64-bit x86)

„Red Hat Linux, 32-bit and 64-bit x86

„SuSE Linux, 32-bit and 64-bit x86

„Fedora Core, 32-bit and 64-bit x86

„FreeBSD, 32-bit and 64-bit x86

„Other versions of Linux, 32-bit and 64-bit x86, using the open source Linux 2.4 or 2.6 kernel driver

For the latest driver versions for all operating systems, see the current Release Notes, at http://www.3ware.com/support.

Other Requirements

„Adequate air flow and cooling

„Adequate power supply for drives

„3DM 2 (3ware Disk Manager), a browser-based application used to configure and maintain RAID units, requires one of the following browsers:

„Internet Explorer 5.5 and later

„Mozilla Firefox 1.2 and later

„Netscape 7 and later

„Konquerer 3.5.1 and later

In addition:

„JavaScript must be enabled

„Cookies must be enabled

For best viewing, screen resolution should be 1024 x 768 or greater, with 16-bit color or greater.

63ware 9690SA SAS/SATA RAID Controller Installation Guide

Image 10
Contents 3ware 9690SA SAS/SATA RAID Controller Trademarks CopyrightDisclaimer Table of Contents About this Guide Contents of this Package Getting Started3ware 9690SA SAS/SATA RAID Controller Installation Guide 9690SA RAID Controller Card ModelsCables CablesOther Available Cables Multi-lane Cable Serial ATA SFF-8087System Requirements Motherboard and Slot RequirementsOperating System Requirements Safety Information Site SelectionProtecting Equipment and Data Installation Considerations Tools You Need Before You StartInstall the Controller in the Computer Inserting Controller Into PCI Express Slot Attach the Cables to Your Controller Connect the Cables to Backplanes External Enclosure ConnectionConnect Battery if appropriate Finishing Up the RAID Controller InstallationConfigure Your RAID Arrays Check Installation and Close the CaseInstalling a Battery Backup Unit Items in Remote Battery Installation PackageInstalling the Control Module To install the control module Installing the Remote Battery BBU control module connected to the controllerThree locations for mounting battery on remote board Attaching the battery module to the remote board Installing the Remote Battery Replacing the Battery Removing the power cable from the BBU module Removing the battery module Sales and ordering information Feedback on this manual
Related manuals
Manual 31 pages 300 b