3ware Disk Manager (3DM 2)
Figure 18. However, if the unit was a Single Disk, only information about one disk would be shown.
Details on this page may include all or some of the following information described below.
To see details about a particular drive, click the Port #. You’ll see a list of all drives, with the drive you selected highlighted.
Status. The operational status of the unit or subunit: OK, Rebuilding, Initializing, Verifying, Degraded, or Inoperable (missing drives). When a unit is Rebuilding, Initializing, or Verifying, the percentage (%) complete is also shown.
Capacity. The total capacity of the unit (capacities of subunits are not shown).
Type. The type of unit or subunit it is. RAID 0, RAID 1, RAID 5, RAID 10, RAID 50, Single Disk, Spare, JBOD, or Disk
Stripe. The stripe size of the unit, if applicable.
Subunits. If the unit has subunits, details of the subunits are shown.
Port #. If the Type is Disk, Single Disk, JBOD, or Spare, the port to which the drive is connected is shown. For multiple drive units, the port numbers are shown in the subunits section. The port number is a link to the Drive Information page.
50 | 3ware 9000 Series Serial ATA RAID Controller User Guide |