AOM - 7694
Installation Instructions
BEFORE YOU BEGIN INSTALLATION:
Before drilling, be sure that no cable or wiring is on the other side. Clamp all wires securely to reduce the possibility of them being damaged during installation and use.
Keep all cables away from hot or moving parts and electrically noisy components.
Wiring Definitions:
Power Connection:
Camera 1 Input:
Camera 2 Input:
Camera 3 Input:
Camera 4 Input:
LCD Panel:
General:
Pin 1 | CHANNEL 1 TRIGGER |
Pin 2 | CHANNEL 2 TRIGGER |
Pin 3 | CHANNEL 3 TRIGGER |
Pin 4 | POWER IN DC (10 TO 32V) |
Pin 5 | AUDIO/MUTE (AUDIO ON/OFF) |
Pin 6 | CHANNEL 4 TRIGGER |
Pin 7 | GROUND |
Pin 8 | |
Connection for tilt camera or camera | |
| extension cable |
Connection for camera or camera extension cable | |
Connection for camera or camera extension cable | |
Connection for camera or camera extension cable | |
1.Choose the monitor and camera locations.
2.Install all required cables in vehicle. A 3/4" (19mm) hole should be drilled for passing camera cables through vehicle walls, barriers, etc.
Install split grommets where applicable. If additional cable protection is required, install convoluted tubing over the cable.
3.After cable/wiring has been routed and components are in place, temporarily make all system connections and perform a system function check. If the system does not operate properly, see the troubleshooting section.
4.Make sure all cables are routed away from hot or moving parts and away from sharp edges. Secure cables with wire ties.
10