English
card that uses the PCI PME (Power Management Event) signal to remotely wake up the PC.
Important:
If you are using a modem add-in card, the 5VSB power source of your power supply must support a minimum of ≥ 720mA.
Wake-On-LAN
The Wake-On-LAN function is applicable only when you are using a LAN add-in card that has the same function. It allows the network to remotely wake up a Soft Power Down (Soft-Off) PC. Your LAN card must support the remote wakeup function.
Important:
The 5VSB power source of your power supply must support
≥720mA.
Wake-On-Keyboard
This function allows you to use the keyboard to power-on the system.
Important:
•The power button will not function once a keyboard password has been set in the “KB Power On Password” field of the Integrated Peripherals submenu. You must type the correct password to power-on the system. If you forgot the password, power-off the system and remove the battery. Wait for a few seconds and install it back before powering-on the system.
•The 5VSB power source of your power supply must support ≥ 720mA.
Wake-On-USB Keyboard
The Wake-On-USB Keyboard function allows you to use a USB keyboard to wake up a system that is in the S3 (STR - Suspend To RAM) state.
Important:
•If you are using the Wake-On-USB Keyboard function for 2
USB ports, the 5VSB power source of your power supply must support ≥ 1.5A.
