Installation Instructions
Flashguard LED Flasher Module
To Flashguard Xtra
1.Straighten the two LEDs by gently bending them in to the upright position.
2.Peel the backing off the adhesive mounting brackets provided and attach them to the inside of the cover as shown below.
6cm
3.Connect the unit to a suitable 12V supply, observing polarity. The two LEDs will now flash alternately.
4.Slot the PCB into the mounting brackets with the LEDs pointing towards the lens. Bend the LEDs into position if required.
5.Fix the unit to the wall in the same way as an ordinary simulated unit.
Wrigley Street, Oldham, Lancashire. OL4 1HW Tel +44 (0)161 287 5555 Fax +44 (0)161 287 5511