Keyspan DuraWand Portable Scanner manual Battery Information and Warnings

Page 2

The Videx DuraWand is the third bar code reader in the Videx line of portable bar code readers. The DuraWand combines the simplicity of TimeWand I and the durability of TimeWand II. The DuraWand features include:

*Protected read head

*Sapphire scan tip

*Loud audible tone

*Cast metal case

*Replaceable AAA nickel-cadmium batteries

*Direct sunlight reading ability

*Optional infrared read head

*Security reset attached key ring

BATTERY INFORMATION AND WARNINGS

The DuraWand uses four AAA nickel-cadmium batteries. To prolong battery life, press the DuraWand scan button once after you insert the DuraWand into the Recharger / Downloader Station and once after you remove it from the Recharger / Downloader Station. This ensures that the DuraWand is in a low power consumption state, enabling it to accept a charge while it is in the Recharger / Downloader Station and conserve the battery charge while out of the Recharger / Downloader Station. The battery charge will also last longer if you release the scan button between scans.

The Recharger / Downloader Station will only recharge nickel-cadmium batteries. Alkaline batteries must not be recharged. Remove a DuraWand with alkaline batteries from the Recharger / Downloader Station immediately after programming and data transfer has been completed. You may use alkaline batteries in an emergency but do not leave them in the Recharger / Downloader Station any longer than absolutely necessary.

WARNINGS

Do not leave a Durawand with alkaline batteries in the Recharger/ Downloader Station for more than thirty minutes. Doing so will cause damage to the Durawand and/or the Recharger/Downloader Station.

DO NOT put a DuraWand without batteries into a Recharger / Downloader Station. DO NOT mix battery types (i.e. nickel-cadmium and alkaline).

DO NOT mix new and used batteries. Replace all four batteries for optimum battery performance. DO NOT leave a DuraWand with alkaline batteries in the Recharger / Downloader Station any

longer than necessary. A DuraWand with alkaline batteries should be in the Recharger / Downloader Station only for programming and transfer of data.

DO NOT dispose of batteries in fire.

DO transfer data from the DuraWand using the Videx Downloader application before replacing batteries. Any data in the DuraWand will be lost during battery replacement.

DO install the batteries correctly, or you will cause damage to your DuraWand.

1

Image 2
Contents User’s Guide For MacintoshBattery Information and Warnings Replacing the Durawand Batteries Recharging the Durawand Programming and Downloading Tip Videx Downloader Application InstructionsCopying the application from the disk or CD Draining the BatteriesProgramming DownloadingDurawand Maintenance and Troubleshooting Uploading into Alexandria