Muratec F-114P service manual Data Setup, Method

Alignment & Troubleshooting

4.1.4.3 Data Setup

SEND LEVEL

You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm.

Caution : The Send Fax Level is set to the best condition during manufacture. Never change settings arbitrarily.

DIAL MODE

This function can choose the dialing method. *Default : Dial (Dial/Pulse)

MODEM SPEED

You can set the maximum modem speed.

When the fax establishes communication with a remote set the value of the maximum modem speed is checked for both transmitter and receiver. The lowest value is used. It is best set at 33.6Kbps, the default setting.

ERROR RATE

When the error rate is about exceed the set value, the Baud rate automatically adjusts to 2400 bps. This ensures that the error rate remains below the set value.

You can select the rate between 5% and 10%.

CLEAR ALL MEMORY

The function resets the system to factory default settings.

This function is used to reset the system to the initial value when the product is functioning abnor- mally. All the values are returned to the default values, and all the information which was set by the user will be erased.

< Method >

1.Select the [MEMORY CLEAR] in TECH MODE.

2.Push the ENTER button.

3.Select your country. (There are four country groups. Refer to the table below.)

4.Push the ENTER button then it will clear all memory.

NOTICE : Always perform a memory clear after replacing the main board, otherwise the system may not operate properly.

	Country Group	USA/Canada	UK	Russia	South Africa
		USA/Canada	UK	Russia	South Africa
		Mexico	Germany	India
		Brazil	France	Oman
			Italy	Poland
			Spain	Bangladesh
			Austria	Kuwait
			Netherlands	Morocco
	Country		Belgium	Algeria
			Portugal	Pakistan
			Sweden	UAE
			Norway	Bahrain
			Denmark	Sri Lanka
			Finland	Saudi Arabia
			Switzerland	Chile
			Greece	Peru
			Ireland	Argentina
			Turkey	Hungary
				Romania
				Bulgaria
				Czech
Service Manual			4-14