Default Settings
The following are the default LAN (Local Area Network) and WAN (Wide Area Network).
LAN (Management)
•Static IP Address: 192.168.1.1;
•Subnet Mask: 255.255.255.0;
•Default Gateway: blank;
WAN (Internet)
•Empty: Once you have run through ‘ADSL Quick Setup’ you will have a saved WAN connection;
•Default connection type: PPPoE (most common for Australian ISPs);
•VPI / VCI: 8 / 35;
Modem Access
•Username: admin
•Password: admin
Restore Factory Default Setting
Restore Factory Defaults will reset the NB9/NB9W to its factory default configuration.Occasionsmay present themselves where you need to restore the factory defaults on your NB9/NB9W such as:
•You have lost your username and password and are unable to login to your NB9/NB9W’s web configurationpage;
•You have purchased your NB9/NB9W from someone else and need to reconfigurethedevice to work with your ISP;
•You are asked to perform a factory reset by NetComm Support staff
In order to restore your NB9/NB9W to its factory default settings, please follow these steps:
•Ensure that your NB9/NB9W is powered on (for at least 10 seconds);
•Use a paper clip or a pencil tip to depress the reset button for ten seconds and release. At this point, the reset is in progress. Do not power off the unit at this point;
•When indicator lights return to steady green, reset is complete. The default settings are now restored. The entire process takes about 45 seconds to complete;
•Once you have reset your NB9/NB9W to its default settings you will be able to access the device’s configuration web interface using http://192.168.1.1 with username ‘admin’ and password ‘admin’;
10 | NB9/NB9W ADSL2+ VoIP Router |
| YML790 Rev8 |