Mobile Mark wap11 manual TCP/IP Setup for Windows NT, Select Use the following IP Address

Instant Wireless™ Series

TCP/IP Setup for Windows NT 4.0

1.Click the Start button, select Settings, and open the Control Panel. Inside the Control Panel, double-click the Network icon.

2.When the Network window appears, click the Protocols tab. Then, click the Add button.

3.Find the TCP/IP protocol in the Select Network Protocol field. Click on it once and then click the OK button.

4.When asked if you want to use DHCP, choose No.

5.If asked to supply your Windows NT CD, do so. NT will copy the neces- sary files to your system. You may have to switch between the Access Point’s Setup CD and the NT CD.

6.When TCP/IP appears in the Network Protocols window, click the Bindings tab. Windows will store your new bindings.

7.Click the Protocols tab. Then, select TCP/IP.

8.Click the Properties button. Select the type of network adapter you have from the Adapters box and select Specify an IP Address.

9.Enter the computer’s IP Address and Subnet Mask. Check with your net- work administrator for your settings.

10.Enter your Default Gateway if you have one.

Note: a Default Gateway is not required. Check with your network administrator.

11.When you finish, click the OK button. If NT asks about WINS, ignore it.

12.When the Network window reappears, click the Close button. Restart your computer when prompted. TCP/IP has now been successfully installed.

Wireless Network Access Point

TCP/IP Setup for Windows 2000

1.At the Windows 2000 desktop, right click My Network Places. Then, right click Local Area Connection. Choose Properties.

2.If the TCP/IP Protocol is listed for your network adapter, go to step five. Otherwise, click the Install button.

3.When the Component Type window appears, select Protocol, and click the Install button.

4.Select Internet Protocol (TCP/IP) from the list and click the OK button.

5.When the Network window reappears, select TCP/IP, and click the Properties button.

6.Select Use the following IP Address.

7.Enter an IP Address for the computer, along with a Subnet Mask and Default Gateway. Then, click the OK button. If you do not have these val- ues, consult your network administrator.

8.When the Network window reappears, click the OK button. Restart your computer. TCP/IP has now been successfully installed.