Mobility Electronics NP644 manual Advanced

Page 21

Advanced

In the Advanced page you can conﬁgure advanced settings of your 108Mbps Wireless Network USB Adaptor

FieldDescription

Encryption: There are four options available: Disable (WEP), Enable (WEP), WPA and WPA-PSK. The default setting is set to “Disable”. Enable and Disable refer to WEP data encryption feature. If Enable is selected, you will be required to select the Authentication mode from the drop down list. If WPA is selected, conﬁguration is enabled. Select the “conﬁguration” button.

You will then be prompted with the following pop up window.

NP644 IEEE 802.11g Wireless Network USB Adaptor	21
YML787 Rev1

Image 21

Contents Page Contents Introduction Product FeaturesSystem Requirements Wireless TerminologyWireless Security Terms Getting to Know Your NP644 Package ContentsLink LED IndicatorsUtility Installation Installing the NB644NP644 Ieee 802.11g Wireless Network USB Adaptor YML787 Rev1 YML787 Rev1 NP644 Ieee 802.11g Wireless Network USB Adaptor YML787 Rev1 Driver Installation NP644 Ieee 802.11g Wireless Network USB Adaptor YML787 Rev1 YML787 Rev1 Optional Link Information Using the Wireless UtilityFieldDescription Configuration Tx Rate Preamble Advanced YML787 Rev1 Default Key Select one of the 4 keys to use Network Key Site Survey FieldDescription About Us Ascii Appendix a GlossaryBSS CSMA/CA CSMA/CDDhcp Dsss ESSEssid Ieee HEXPpdu PlcpPsdu RTSSsid WEP TCP/IPContact Information Appendix B Registration and Warranty InformationCopyright Information Customer Information Product Warranty Limitations of Warranty