Microstar G52-MA00514 manual Access Mode, Floppy 3 Mode Support, Video, Halt On

BIOS Setup

ing items. Enter the information directly from the keyboard. This information should be provided in the documentation from your hard disk vendor or the system manufacturer.

If the controller of HDD interface is SCSI, the selection shall be “None”.

If the controller of HDD interface is CD-ROM, the selection shall be “None”.

Access Mode	The settings are CHS, LBA, Large, Auto.
Capacity	The formatted size of the storage device.
Cylinder	Number of cylinders.
Head	Number of heads.
Precomp	Write precompensation.
Landing Zone	Cylinder location of the landing zone.
Sector	Number of sectors.

DriveA/B

This item allows you to set the type of floppy drives installed. Available options are None, 360K, 5.25 in., 1.2M, 5.25 in., 720K, 3.5 in., 1.44M, 3.5 in., 2.88M, 3.5 in.

Floppy 3 Mode Support

Supported by the BIOS, the selected diskette drive can read 720-KB, 1.2-MB, and 1.44-MB diskettes. Setting options: Disabled, Drive A, Drive B, Both.

Video

The setting controls the type of video adapter used for the primary monitor of the system. Available options are EGA/VGA , CGA 40, CGA 80 and Mono.

Halt On

The setting determines whether the system will stop if an error is detected at boot. Available options are:

All Errors	The system stops when any error is detected.
No Errors	The system doesn’t stop for any detected error.
All, But Keyboard	The system doesn’t stop for a keyboard error.
All, But Diskette	The system doesn’t stop for a disk error.
All, But Disk/Key	The system doesn’t stop for either a disk or a
	keyboard error.

3-7