Micro Technic PV-1075-CAR user manual Connectors, Input connector KL2, Output connector KL1

Page 6

Users Manual & Installation Guide

PV- 1075: NIMH BATTERY PACK WITH CHARGER

Connectors

The PV-1075 is equipped with four connectors:

Input connector (KL2)

Power into PV-1075 is supplied through KL2 that is a two-pole removable screw clamp connector. The layout of this connector is shown on the connection drawing above. The voltage used must be in the interval of 18-36V DC (PV-1075-CAR: 10.8V – 13.2V).

Output connector (KL1)

Mains power and battery power can be drawn from connector KL1 that is a three-pole removable screw clamp connector. If used as a back-up module for Micronix PV-5127, this connector must be connected to the power input connector (KL2), on PV-5127, as shown on the connection drawing above.

Page 6 of 9

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Micronix PC/104 Power Supply Table of contents Revision history Revision number Reason for change DateAccessories General informationOrdering codes Block Diagram DescriptionConnectors Input connector KL2Output connector KL1 PC/104 connector CN1 Battery chargerBattery connector J1 Charging indicatorsTechnical data Mains inputMechanical layout
Top Page Image Contents