6. Protection
The LS700P has circuitry to prevent clipping, over current and over excursion. The circuitry does not alter the frequency response as the level changes. At high levels the limiter will limit the gain of the LS700P and hence if the user attempts to set the subwoofer level control at high levels the resulting setting will be incorrect. The level control should be set while operating at low levels (under 10 watts). If the level control is set to high due to setting it at high operating levels the input circuit will clip and the dynamics of the bass will be lost. This can happen without audible distortion since the filters will filter out the distortion.
LS700P CONFIGURATION EXAMPLES
LS700P
POWER |
|
|
| SUBWOOFER | ||||
AMPLIFIER |
|
|
|
|
|
|
| SPEAKER/s |
|
|
|
|
|
|
|
|
|
Output
ONE SUBWOOFER, WITH MONO SYSTEM
Left | Right | |
| ||
SPEAKER |
| SPEAKER |
| POWER | |
LS700P | AMPLIFIER | LS700P |
SUBWOOFER |
| SUBWOOFER |
TWO SUBWOOFERS PER SYSTEM
LS700P
POWER | SUBWOOFER | |
AMPLIFIER |
| SPEAKERS |
Left | Left |
|
|
| |
Right |
|
|
| Right |
|
élite PROCESSOR
L | MID/ | SUB | R | MID/ | SUB |
INPUT | HI | OUT | INPUT | HI | OUT |
|
|
|
|
|
|
POWER
AMPLIFIER
R
AMP IN
L
LS700P
SUBWOOFER
Left
Right
AMP OUT
ONE SUBWOOFER, WITH STEREO SYSTEM
ONE SUBWOOFER USING ÉLITE PROCESSOR
Note: The LS700P
E160 cabinets. The support tube can be adusted up to it’s full 5’4” extension safely as long as the LS700P is not
inclined more than 10˚ (10 degrees).
WARNING: Larger or heavier cabinets should not be used!
3