Teledyne HPS-10 configuration jumpers, Jumper Location, Display Configuration, 100.0, 1.000

Models: HPS-10

1 16

Page 13

page 13

Image 13

Contents

HASTINGS MODEL HPS-10 POWER SUPPLYINSTRUCTION MANUALRevision A Document Number Manual Print HistoryInstallation SpecificationsInternal Adjustments Warranty and Repairpage General Information SECTIONSpecifications Introductionpage SECTION InstallationReceiving Inspection Mounting2 Attach brackets to the side of the power supply 1 Slide power supply into panel from the frontTo panel mount the HPS-10 3 Tighten screws against panel See Figure below115 +5% VA C ANALOG OUT Hastings HPS-10 Power Supply Cable ConnectionsBLACK OR A NG E YELLOW GREEN + SHIELD BLUE page SECTION Operating InformationNormal Start-up Analog OutputFull Scale Display ConfigurationAnalog Output Internal AdjustmentsDisplay Configuration configuration jumpersJumper Location 100.0page Warranty Policy Warranty and RepairNon-Warranty Repair Policy SECTIONpage