Manuals / Teledyne / Computer Equipment / Power Supply

Teledyne HPS-10 instruction manual Section, General Information, Introduction, Specifications

Models: HPS-10

1 16

Download 16 pages 59.63 Kb

Page 5

Image 5

SECTION 1

General Information

Introduction

The Hastings Power Supply (HPS-10) supplies stable ±15VDC specifically for Hastings mass flowmeters (HFM-200 and HFM-300 series). The flowmeter returns a 0-5VDC output that is proportional to flow that is digitally displayed.

Specifications

Output voltage	±15 VDC ± 2.5 %
Power input	115VAC ±10%, 50/60 Hz
Signal input	0 - 5 VDC
Display	3½ digit
Analog output voltage	0 - 5 VDC
Min. load impedance	10 kW
Display type	0.52” (13.2mm) red LEDs
Warm up time	15 min
Operating temperature	0 - 500C
Load regulation	±1% (10 mA-30 mA)

page 5

Page 5

Image 5

Teledyne HPS-10 instruction manual Section, General Information, Introduction, Specifications

Contents

HASTINGS MODEL HPS-10 POWER SUPPLYINSTRUCTION MANUALRevision A Document Number Manual Print HistoryInstallation SpecificationsInternal Adjustments Warranty and Repairpage General Information SECTIONSpecifications Introductionpage SECTION InstallationReceiving Inspection Mounting2 Attach brackets to the side of the power supply 1 Slide power supply into panel from the frontTo panel mount the HPS-10 3 Tighten screws against panel See Figure belowBLACK OR A NG E YELLOW GREEN + SHIELD BLUE Hastings HPS-10 Power Supply Cable Connections115 +5% VA C ANALOG OUT page SECTION Operating InformationNormal Start-up Analog OutputFull Scale Display ConfigurationAnalog Output Internal AdjustmentsDisplay Configuration configuration jumpersJumper Location 100.0page Warranty Policy Warranty and RepairNon-Warranty Repair Policy SECTIONpage