Matsushita CF-18JHU70TW service manual 02D0 System cache error Cache disabled

Page 10

02D0 System cache error - Cache disabled

Contact Panasonic Technical Support.

02F0: CPU ID:

CPU socket number for Multi-Processor error.

02F4: EISA CMOS not writable

ServerBIOS2 test error: Cannot write to EISA CMOS.

02F5: DMA Test Failed

ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers.

02F6: Software NMI Failed

ServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).

02F7: Fail - Safe Timer NMI Failed

ServerBIOS2 test error: Fail-Safe Timer takes too long.

device address Conflict

Address conflict for specified device.

Allocation Error for: device

Run ISA or EISA Configuration Utility to resolve resource conflict for the specified device.

Failing Bits : nnnn

The hex number nnnn is a map of the bits at the RAM address which failed the memory test. Each 1 (one) in the map indicates a failed bit. See error 230,231 or 232 for offset address of the failure in System, Extended or Shadow memory.

Invalid System Configuration Data

Problem with NVRAM (CMOS) data.

I/O device IRQ conflict

I/O device IRQ conflict error.

Operating System not found

Operating system cannot be located on either drive A: or drive C:. Enter Setup and see if fixed

disk and drive A: are properly identified.

Parity Check 1 nnnn

Parity error found in the system bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the address, it displays ????. Parity is a method for checking errors in binary data. A parity error indicates that some data has been corrupted.

Parity Check 2 nnnn

Parity error found in the I/O bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the address, it displays ????.

Press <F1> to resume, <F2> to Setup

Displayed after any recoverable error message. Press <F1> to start the boot process or <F2> to enter a Setup and change the settings. Write down and follow the information shown on the screen.

3-2

Image 10
Contents CF-18 Page Laser Safety Information Page Page Contents Page Power-On Self Test Boot Check Stuck key 02D0 System cache error Cache disabled Equipment PreparationOutline of Self Diagnostic Tests Self Diagnosis TestAutomatic Test List of main test itemsLAN Test Modem Test Wireless LAN Test Peripheral TestTest Selection End of test Error Messages and Troubleshooting Test classification Screen display test items ContentsWiring Connection Diagram Disassembly/Reassembly Removing the Rear Cabinet Removing the SpeakerRemoving the DU Lid Unit Removing the Audio PCB Removing Main PCB Removing the Wireless Module Port PCB and Modem PCBRemoving PAD PCB and I/O Removing the CPU Heat Plate and Lithium Battery Removing LED PCB and SwitchRemoving the Display unit Removing the LCD Hinge DXYN2+J6FNLRemoving Each Cover Pcmcia LID AssyExploded View BT1 2 + 0.02N m + 0.2kgf cm K83 K82 K13 K10 K20 K401 K600 K80 K409 K80-9 K210 K200-30 K211 K200-30-4 18 + 0.02N m + 0.2kgf cm Screw tightening torque Replacement Parts List Packing Material USB LID Rubber DFHR3535ZA Speaker Cable Tube LCD Front CABINET/TS Panel Assy DXYN2+J6FNL Screw DFHR6220ZA Dimm Holder