Installation and Initial Setup
■Unpacking
Carefully unpack the V-R151DP-AFSD/AFHD monitor and verify that the following items are included:
•V-R151DP-AFSD/AFHD Monitor with Attached Rack Ears
•V-PS12-5V-1 Power Supply with Conxall 2-Pin Twist-Lock Connector
•Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage, immediately contact Marshall Electronics at (800) 800-6608. If you are not located within the continental United States, call +1 (310) 333-0606.
■Installation
The V-R151DP-AFSD/AFHD monitor is shipped with pre-installed removable rack ears, allowing the monitor to be installed in an EIA standard 19-inch rack (occupying 6 RU). When installed in a rack, the unit can be rotated up to 360° to achieve the desired viewing angle.
Alternately, the V-R151DP-AFSD/AFHD can be configured as a desktop monitor with an optional table top stand (Marshall Part No. VP-0149-SF-A).
A VESA standard 75mm hole pattern also allows custom mounting installations.
■Connections and Power-On
Plug the V-PS12-5V-1 power supply into an AC power source (100-240 V @ 50/60 Hz). Attach the 2-pin twist-lock connector to the back of the monitor. Please note that 12-17VDC can be also supplied directly to the monitor from a variety of sources. The monitor will draw approximately 3 Amps at 12 Volts in operation.
Connect the required cables for video signal input and output. (Power must be applied to the V-R151DP- AFSD/AFHD for the active loop-though outputs to be activated.) All BNC connectors are rated at 75Ω.
Turn on the unit by pressing the power button located on the front panel. Select a video input by pressing the corresponding input select button.
