SPECIFICATIONS
| LCD |
| Type | 17” diagonal viewable screen |
|
|
|
| TFT (Thin Film Transistor), |
|
|
|
| Active Matrix Panel, 0.264mm pixel pitch |
|
|
| Color Filter | R, G, B vertical stripe |
|
|
| Colors | up to 16.2 mio. colors |
|
|
| Glass surface | |
| Viewing |
|
|
|
| Angles |
| Left / Right | 75° / 75° |
| (CR>10) |
| Up / Down | 60° / 65° |
| Contrast Ratio |
| Typ. | 450 : 1 |
|
| |||
|
| |||
| Luminance of White |
| Typ. | 250cd/m² |
|
| |||
|
| |||
| Response Time |
| Typ. | 25ms |
|
| |||
|
| |||
| Compatibility |
| PC | IBM XT, AT, 386, 486, Pentium or PS/2 |
|
| |||
|
| |||
|
|
|
| and compatibles (from VGA up to |
|
|
|
| 1280 x 1024 @ 75 Hz NI.) |
| Refresh Rate |
| Max. | 1280 x 1024 @ 75Hz NI |
|
| |||
|
| |||
|
|
|
| (60Hz for optimal display) |
| Connectors |
| Input Signal | |
| Power |
| Input | AC |
|
| |||
|
|
| Consumption | 40 watts (Maximum) |
| Display Area |
| Max. | 338mm (H) x 270mm (V) |
|
| |||
|
| |||
| Operating |
| Temperature | 32°F to 104°F (0°C to 40°C) |
|
| |||
|
|
| Humidity | 20% RH to 90% RH (no condensation) |
|
|
| Altitude | To 10,000 feet |
| Storage |
| Temperature | |
| Conditions |
| Humidity | 5%RH to 90%RH (no condensation) |
| Dimension |
|
| 459mm(W) x 467mm(H) x 165mm(D) |
| Weight |
| Net | 7.5kg |
|
|
|
|
|
TROUBLESHOOTING
No power.
üFlip the power switch ON. The Power LED turns on.
üMake sure AC power cord is securely connected to the power jack and to a power outlet.
Power on but no screent image.
üMake sure the video cable attached with this monitor is tightly secured to the video output port on the back of the computer.
üAdjust the brightness and contrast.
Image is unstable, unfocused.
üUse
üIf the image is still unstable after
üCheck whether the resolution or refresh rate in windows display setting is beyond supported range(please refer to the specification of supported mode).
Flickering.
üNot enough power is being supplied to the miro TD271 Monitor. Connect the miro TD271 Monitor to a different outlet. If a surge protector is being used, there may be too many devices plugged in.
üSee Timing Guide in this manual with a list of refresh rates and frequency settings showing the recommended setting for the miro TD271 Monitor.
Wrong or abnormal colors.
üIf any colors (Red, Green, or Blue) are missing, check the video cable to make sure it is securely connected. Loose pins in the cable connector could cause a bad connection.
üConnect the miro TD271 Monitor to another computer.
üCheck the graphics card for proper sync scheme (or sync polarities) to match the miro TD271 Monitor’s specifications.
14 | 15 |