Pride Mobility Dynamic DX manual Driving in Standard Mode Configuration

6 Basic Operation Manual SCR

SCR CONTROLS

The SCR has only two built-in controls: the On/Off Switch and the Mode Switch (see figure 1). The On/Off Switch simply controls power to the SCR. The Mode Switch cycles the SCR through eight possible program modes. Only five of the eight possible program modes are used in the Standard Mode Configuration. All five program modes are Drive Modes (see Standard Mode Configuration).

STANDARD MODE CONFIGURATION

Quantum Rehab’s Standard Mode Configuration for the SCR encompasses five drive programs, all of which control driving speed as a percentage of maximum speed. The slowest is Drive Mode 1; the fastest is Drive Mode 5. Actual maximum speed varies according to the power chair model.

Driving in Standard Mode Configuration

Driving in Standard Mode Configuration is simple. Power up the SCR using the On/Off Switch (either onboard or plugged into the external On/Off Switch jack). The LCD Display will show Drive Mode 1 and prompt the user to select one of three options (see figure 2):

1.Previous (down arrow)

-Returns the SCR to the previous

state (in this case, powered

	down)	DRIVE MODE 1
			YES
		PREVIOUS
			NEXT
2.	Yes (right arrow)
	-Selects Drive Program 1
3.	Next (up arrow)
	-Selects the next option (in this

case, Drive Program 2) Figure 2. Drive Program Selection

Using the input device, select the drive program most appropriate to the current environment, e.g., indoor setting versus outdoor setting. Choosing the “Next” command will cycle the SCR through the drive programs. The LCD display will change with each option selection.