Note: On changing the housing position you should be careful to not get your fingers too near to the opening on the rear side of the housing as they might get pinched there.
4. Driver Installation
Important Note:
A new calibration is always necessary if another touchscreen was connected to the computer or if the screen resolution was changed. This means that the calibration between touchscreen and computer is adjusted to the mechanical features of the particular touchscreen which was connected to the computer at that time.
A serial Touch Controller is integrated into the Touch Commander. The default setting is 9600 Bps. Normally this is clearly recognized by the setup programs. If, however, it is not clearly recognized, the adjustment can be done manually or by restarting the corresponding setup program.
Information for the driver installation is in the file:
D:\TOUCH\MC15\TouchKit\Document\TouchKit Manual v3.1.4.pdf
You can find detailed information in the path, named with your operating system. (The CD- ROM drive of your
5. Care
Before cleaning, switch off the power supply. A soft cloth moistened with a mild cleaning agent can be used for cleaning the housing. For cleaning the screen it is better to use a soft paper towel moistened with a mild household cleaning agent. For cleaning the surface do not apply the cleaning liquid directly but use a moistened paper towel. Please avoid getting liquid into the housing.
6.Troubleshooting 6.1 General Points
Attention:
The Preh Touch / Screen Commander does not contain any electronic components that can be replaced or repaired by the user. Consequently you should not try to do your own repair work. Moreover, you would lose all warranty claims for this product. Activating the touch sensor surface must not be done with a sharp object, such as credit card, long finger nails, ring, etc. Sharp or pointed objects will cause damage to the touch sensor and are not covered under warranty
If the Touch/Screen Commander must be returned for service, it must be packed in it's original packing material. If this is not done, the sender will be made responsible for possible transport damage.
14 | subject to change without prior notice | 05.2004 |
| Preh KeyTec GmbH, |
|