Routing the Cables

Connect the 6 pole plug of CCBLA-238 to “CR” port and connect each 8 pole plug to the connector marked “signal cable from POS Printer” at the rear of one of the cash drawer. In this way, the Jiva series is capable of controlling two cash drawers independently through software command.

Fix this End of the Cover First

Route Cables under the Cover Connect this End to Main Unit

This End to Other Devices

Place all the cables required for connections to the Jiva TP/LT-5700G or Jiva TP/LT-5800G except those for special application purposes into the cable passage. Insert one end of the cable passage cover under the adjacent cover plate and screw on the two screws. Be sure not to damage any of the cables during this operation.

Now, turn the adjustable stand assembly back to normal orientation and arrange all cables to come out of the area for mounting main unit from the bottom edge for ease of later operation.

PREPARING THE MAIN UNIT

On the back of the main unit, there are 4 matching pegs and a service window. Push open the service window in the direction as indicated in the picture, one can find a button cell battery socket, two 1 x 2 (JP6, 9) and two 1 x 3 headers (JP11, 16) with 1 jumper each and two 2 x 3 header (JP13, 14) with 2 jumpers each. Though it is possible that the contents in the service window may change as time develops.

Service		4 Matching
Window		Pegs
Push
Open
To The
Right

CAUTION

Risk Of Explosion If Battery Is Replaced By An Incorrect Type

Dispose Of Used Batteries According To The Instructions

This battery socket accepts a 3 V button cell Lithium battery (CR2032)

Part 7