Velodyne Acoustics SC-600 user manual Subwoofer Connection Terminals, Power Cord Adapter, Fuse

Page 10

Figure 3: Speaker-Level Connection.

(17) Subwoofer Connection Terminals

Connect the output terminals to the subwoofer being controlled by the SC-600 amplifier. Only connect ONE subwoofer to the red/black pair of subwoofer output terminals - DO NOT connect multiple subwoofers to the terminals in any configuration.

Caution!!!

To avoid damage to your SC-600 amp and subwoofer, be sure to maintain correct polarity when making all speaker connections; red (positive) to red, and black (negative) to black. Be sure that all connections are tight, and that there are no loose strands or frayed wires.

(18) Power Cord Adapter

Connect the detachable power plug to this male interface connection. The detachable cord allows for easy replacement should the original become damaged.

(19) Fuse

If the unit is not functioning, check the fuse. If the fuse is blown, replace with an identically rated fuse. If the fuse blows again, refer the unit for service.

(20) Main Power Switch

Press the POWER switch to the ON position to activate the amplifier. If the unit is to be left unused for an extended period of time, move this switch to the OFF position to prolong the life of the amplifier.

(21) 115V or 230V Operation Selectable Switch

 

This selectable voltage switch is factory preset for the correct voltage in the geographical

region in which the product is sold. To retain full Velodyne warranty coverage, this switch

should ONLY be operated by a Velodyne factory authorized service representative during a

FULL factory-authorized mains voltage change procedure. Should anyone other than a

Velodyne factory authorized service representative attempt to perform a mains voltage

change in any way, the warranty for the product will be terminated. In this case, Velodyne

assumes no liability for any and all injuries to any persons involved, or for any property

damage, whether to the subwoofer or any other property involved or damaged as a result of

this unauthorized mains voltage change.

 

.w w w . v e l o d y n e . c o m

SC-600 Amplifier User’s Manual 7

Page 9 Page 11
Image 10
Page 9 Page 11
Contents SC-600 Amplifier U t i o n Table of Contents N gr a t u l a t i o n s Product FeaturesPrior to Installation SC 600 Subwoofer AmplifierSC-600 IW In-Wall Etup ChecklistSC 600 IW, SC 600 IF/IC Subwoofers SC-600 IF/IC In-Floor/In-CeilingS ta l l a t i o n Front Panel Controls and DisplaysRear Panel Connections Option 12 12V Trigger Signal Sensing Auto On/Off SwitchIR Input 13 RS-23221 115V or 230V Operation Selectable Switch Power Cord AdapterMain Power Switch Subwoofer Connection TerminalsAbout LOW Pass Crossovers Disabling the Low Pass Cr ossover Subwoofer Dir ectWord about Subwoofer Placement Word about Interconnect CablesSelecting the Subwoofer to be Controlled Model LED DisplayA ge Remote Contr olW . v e l o d y n e . c o m Musical Style Suggested Preset Restoring Defaults Care of your Amplifier and SubwooferTroubleshooting and Service Thank You for Purchasing an SC-600 AmplifierSpecification s Specification SC-600 Subwoofer AmplifierSC in and OUT Por t Pin Configuration Appendix a RS-232 Serial Overview and CommandsCom Por t Setup Runtime Command Format Byte Number Byte DescriptionW . v e l o d y n e . c o m 115 Velodyne ProductsRegister. . . on Line . . . It’s faster . . . and easier Velodyne Acoustics, Inc
Top Page Image Contents