Troubleshooting

If you encounter a hardware problem, we recommend that you review the following suggestions before calling for service:

General failure

•Are all cables securely plugged?

•Are all system components and peripherals turned on?

•Is the system main power switch on?

•Is the power outlet burned out? You may check this by plugging in and turning on another piece of equipment.

•Are any cables damaged? Are they properly routed and coiled? Entwined cables may cause signal interference.

•Reset the unit

Perform a power reset (unplug the adaptor the from power socket for 5 minutes and then plug the adaptor in again).

Keyboard is dead

•Is the keyboard cable plugged in? Turn off the system and plug in the keyboard.

Caution: Do not plug or unplug the keyboard while the power is on.

BOOTING FROM INTERNAL/EXTERNAL DEVICES

Depending on the configuration of your LC8000 whether it is equipped with either an internal hard-drive or compact flash card or both, the BIOS will be pre-programmed to boot from that particular device. If you need to boot from an external device or if you have upgraded your compact flash card or hard-drive you will need to change settings in the BIOS. The following steps show how to change the boot sequence within the BIOS.

1.Turn on or reboot your system. After a series of diagnostic checks, the following message will appear:

PRESS <Del> TO RUN SETUP

2.Press the <Del> key and the BIOS setup main screen will appear as follows.

AMIBIOS NEW SETUP UTILITY – VERSION 3.31a

►Standard CMOS Features

►Advanced BIOS Features

►Advanced Chipset Features

►Power Management Features

►PNP/PCI Configurations

►Integrated Peripherals

►PC Health Status

►Frequency/Voltage Control

►System Information

Set Supervisor Password

Load Optimal Defaults

Load Fail Safe Defaults

Save & Exit Setup

Exit Without Saving

F1: Help	↑↓: Select Item	+/-: Change Values	F9: Setup Defaults
Esc: Exit	←→: Select Menu	Enter: Select ►Sub-Menu	F10: Save & Exit

LC8000 User Manual Rev. 1