La Crosse Technology WS-6118AL-IT Care and Maintenance, Liability Disclaimer, Batteries Change

Page 6

 

a receivable range from the

 

transmitter.

 

3) Move the units to another

 

location. Interferences from

 

other electrical devices

 

operating on the same signal

 

frequency (915MHz) may

 

prevent correct signal

 

transmission and reception.

Problem:

"OF.L“ appears in the outdoor

 

temperature section of the LCD.

Solution:

1) Wait until the current

 

surrounding temperature cools

 

down or increases. Current

 

temperature is outside of the

 

measuring range of the

 

transmitter. The outdoor

 

temperature will be displayed

 

again once the current

 

surrounding temperature is

 

within the range of the

 

transmitter. Batteries.

CARE AND MAINTENANCE:

Avoid placing the units in areas prone to vibration and shock as these may cause damage.

Avoid areas where the units can be exposed to sudden changes in temperature, i.e. direct sunlight, extreme cold and wet/moist conditions as these will lead to rapid changes which reduce the accuracy of readings.

When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents or scouring agents.

Do not submerge the units into water.

Immediately remove all low powered batteries to avoid leakage and damage. Replace only with new batteries of the recommended size.

Do not make any repairs to the units. Please return it to the original point of purchase. Opening and tampering with the units may invalidate the warranty.

SPECIFICATIONS: Temperature measuring range

Indoor: +14.1ºF to +103.8ºF with 0.2ºF resolution -9.9ºC to +39.9ºC with 0.1ºC resolution ("OF.L" displayed if outside this range)

Outdoor: -39.8ºF to +139.8ºF with 0.2ºF resolution -39.9ºC to +59.9ºC with 0.1ºC resolution ("OF.L“ displayed if outside this range)

Temperature checking interval Indoor: every 20 seconds Outdoor: every 4 seconds

Transmission distance: maximum 330 feet (100 meters) in open field, depending upon surrounding structures, mounting location and possible interfering sources Power source (Alkaline batteries recommended)

Atomic clock: 2 x AA, 1.5V batteries

Transmitter: 2 x AA, 1.5V batteries

Battery life: about 24 months

Dimensions (H x L x W)

Atomic clock: 9.40“ x 8.74“ x 1.23“ / 239 x 222 x 31.4 mm

Transmitter: 5.05” x 1.50” x 0.83” / 128.3 x 38.2 x 21.2 mm

LIABILITY DISCLAIMER:

The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any consequences that occur should an inaccurate reading take place.

This product is only designed for use in the home or office.

This product is not to be used for medical purposes or for public information.

The specifications of this product may change without prior notice.

This product is not a toy. Keep out of the reach of children.

No part of this manual may be reproduced without written authorization of the manufacturer.

BATTERIES CHANGE:

For best performance, batteries should be replaced at least once a year to maintain the best running accuracy. Ensure that the batteries used are new and the correct size.

Please help in the preservation of the environment and return used batteries to an authorized depot.

6

Image 6
Contents Features Atomic Clock This product offersSETTING-UP Outdoor Temperature TransmitterTo Install and Replace Batteries in the Atomic Clock Function KeysManual Time Setting Time Zone SettingLanguage Setting Year SettingSnooze Setting Alarm SettingTo Deactivate the Alarm Changing the Display Mode DAY, SECONDS, and TemperaturesPositioning the Atomic Clock Positioning Outdoor Temperature TransmitterTroubleshooting Foldout Table StandCare and Maintenance Liability DisclaimerBatteries Change Warranty Information