La Crosse Technology WS-6002U Detailed SET-UP Guide Battery Installation, Atomic Clock

Page 5

DETAILED SET-UP GUIDE

I)BATTERY INSTALLATION

Note: To avoid start-up problems make sure that the batteries do not spring free.

Battery Compartment

SET

A) ATOMIC CLOCK

Battery Cover

1)Remove the battery cover, located on the backside of the function buttons.

2)Observe the correct polarity, and install 2 AA batteries.

3)Replace the battery cover.

Note: After the batteries have been installed all the LCD’s (Liquid Crystal Display) will briefly light up. Then the indoor temperature, the date as “1/ 1” and the weekday as “MON” will be displayed. Also, the time will appear as “-:--” for approximately 1 minute. Then the WWVB search is automatically initiated, and a tower icon appears and flashes with the time colon (no tower icon will appear if the WWVB is too weak to be detected). While the WWVB search is being conducted various numbers will appear in the time display. The numbers “0”, “1”, or “8” will appear in the hour position and the seconds will appear in the minute display. The Atomic Clock will either display the WWVB time, or discontinue the

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents WS-6002U Atomic Clock Table of Contents Inventory of Contents Quick SET-UP Guide Atomic Clock Detailed SET-UP Guide Battery InstallationFunction Buttons Program ModeIII DST Daylight Saving Time Setting II Time Zone SettingIvlanguage Selection for the Weekday Time SettingVII 12/24-HOUR Setting Vicalendar SettingViii Selecting F or C II Indoor TemperatureII Wall Mounting MountingFoldout Table Stand Troubleshooting Maintenance & CareProblem SolutionTemperature SpecificationsPower source DimensionsWarranty Information Support@lacrossetechnology.com
Top Page Image Contents