Ultra electronic 3503-1002, 3503-1004 quick start Magicard Sprinter Flip

Quick Start Guide Ultra Electronics Card Systems

78

Avoid touching the tip of the thermal printhead with your hands.

Feed the leading edge of the dye film over the tip of the Thermal Printhead and beneath the two guide bars, where fitted. (Refer to the diagram on the side).

Fasten the end of the dye film onto the Take-up Core with a small piece of adhesive tape, and wind on a couple of turns. Avoid creasing of the dye film and position it centrally on the core.

Page 12 MAGICARD Sprinter Flip