PSC QS6500 manual Installation, Power Supply

Page 7

Installation

The QuickScan® QS6500 linear imager is easy to install and use. The following figure shows the steps to perform an installation. Turn off the host computer before connection. Consult the host terminal’s manual if necessary.

1 2

5

3

$4.50 $2.79 $3.99

4

1.Connect the interface (I/F) cable to the linear imager.

2.Connect the I/F cable to the terminal’s communication port.

3.Connect the power cord to the I/F cable connector if required. Linear imagers that use power off the terminal (P.O.T.) do not require a power supply.

4.If required, connect the AC adapter to the wall outlet.

5.To verify operation, point the linear imager at a bar code and pull the trigger. The linear imager should emit a single beep indicating that the label has been scanned successfully.

The linear imager installation is complete.

Power Supply

Unit requires either a Listed Class 2 or Listed LPS power source which supplies power directly to the linear imager.

Quick Reference Guide

1

Image 7
Contents QuickScan QS6500 PSC Inc PSC INC. Quickscan END User License Agreement QuickScan QS6500 Quick Reference Guide Iii END Power Supply InstallationHow to Scan Troubleshooting LED Class Compliance StatementAlimentation Procédure de lecture Dépannage Interference de la Radio Frequence Netzteil Der Vorgang des Scannens selbst Problembehandlung Hochfrequente Störungen Alimentazione InstallazioneCome eseguire una lettura Risoluzione dei problemi Disturbi in radiofrequenza Conección al Corriente InstalaciónCómo leer Solución de problemas Interferencia de radio frecuencia Adaptador CA/CC InstalaçãoComo operar o linear imager Diagnóstico de Problemas Classe Do LED Interferência de Radio Frequência关于电源 如何扫描 OFF LED 等级 符合法规之声明インストール スキャンの仕方 トラブルシューティング 適合性について EU Directives PSC Inc