Proview XA3 Series manual Installation, Connecting Your LCD Monitor to a Computer

Page 13

Installation

2 Installation

Refer to the owner’s manual of the computer for connections. In the process of connecting external equipment, do not connect any AC power cords to wall outlets until all other connections are completed.

Connecting Your LCD Monitor to a Computer

Method : Analog (D-SUB) Connection

1Turn off the computer and unplug the power cable.

2Connect the signal cable to the D-SUB port on the back of the computer.

3Connect the power cord to the LCD monitor and wall outlet.

2	Connect to the D-SUB
	port

3 Connect to power source

12	Xerox© LCD Monitor User’s Manual

Image 13

Contents LCD Monitor By Xerox Corporation. All rights reserved Table of Contents Europe Recycling PlaceCE Marking Declaration Of Conformity Federal Communications Commission FCC Statement Important Safety Instructions On next Collection service Introduction FeaturesPackage Contents OSD mode, press the / buttons to select the desired menu Front View and ControlsConnecting Your LCD Monitor to a Computer InstallationEnglish Installing Your LCD Monitor OSD Menu Using the OSD MenuOSD Options Picture Menu Advanced Menu Osd h. position Options MenuOsd v. position Utilities Menu Osd timeoutOsd background Languages1280 x 1024 resolution is not available in 15 LCD monitor Preset Mode Timing ChartTechnical Information SUB Connector PIN Assignment Visual Inspection Plug and PlayPermanently unlit or lit pixels Monitor will not turn on TroubleshootingNo picture Poor picture or abnormal pictureModel Speciﬁcations281 281 530-4104 Fax Hours 8AM ~ 6PM Central Time Authorized Service Centers