Proview XM7-19w manual Method 2 Digital DVI Connection

Page 15

Installation

Method 2: Digital (DVI) Connection

1Turn off the computer and unplug the power cord.

2Connect the DVI signal cable (not included) to the DVI port on the back of the computer.

3Connect the audio cable to the line-in port on the back of the computer.

4Connect the power cord to the LCD monitor and wall outlet.

5Press the button, located on the bottom side of the main unit to turn the monitor on, then turn the computer on. If the monitor displays an image, the monitor is successfully installed. If no image is displayed, check all connections.

6When the DVI and VGA input ports are connected at the same time, press down the AUTO button after 3 seconds to switch between the VGA mode and DVI mode.

3 Connect to the Line-in port

2	Connect to the DVI port
4	Connect to power source

14	Xerox© LCD Monitor User’s Manual

Image 15

Contents LCD Monitor By Xerox Corporation. All rights reserved Table of Contents Europe Recycling PlaceCE Marking Declaration Of Conformity Federal Communications Commission FCC Statement Important Safety Instructions On next Collection service Introduction FeaturesPackage Contents English Menu Front View and ControlsConnecting Your LCD Monitor to a Computer InstallationSUB only SUB/1 DVI Method 2 Digital DVI Connection HOW to GET Support for Your Wide SCREEN? Using Your LCD Monitor OSD Menu First, release the LCD monitor’s stand lock 30o Next, adjust the height of the stand’s postOSD Menu Using the OSD MenuOSD Options Picture Menu Advanced Menu Volume Audio MenuMute Options Menu Osd h. positionOsd v. position Languages Osd timeoutUtilities Menu Osd backgroundTechnical Information Preset Mode Timing ChartPIN Description DVI Connector PIN AssignmentSUB Connector PIN Assignment Plug and Play Visual InspectionPermanently unlit or lit pixels Poor picture or abnormal picture TroubleshootingMonitor will not turn on No pictureModel Speciﬁcations281 281 530-4104 Fax Hours 8AM ~ 6PM Central Time Authorized Service Centers