SPECIAL NOTES ON LCD MONITORS
The following are normal with LCD Monitors and do not indicate a problem.
∙When the LCD Monitor is first powered on, the picture may not fit in the display area. This is because of the type of computer graphics system that is used. In such case, adjust the picture position to a desired image (See Operating the Monitor).
∙The screen may flicker during initial use. Turn off the power and then turn it on again the flickering should disappear.
∙Users may notice some uneven brightness on the screen depending on the desktop resolution they use. It is normal for LCD Monitors to show uneven brightness.
∙Due to the nature of the LCD displays, images displayed on the screen for long periods of time may still appear after the screen content has been changed. This phenomenon can be corrected, over time, by switching display content or leaving the monitor off for a number of hours.
∙If the screen becomes dark, flickers, or does not
CLEANING
WARNING
If you dropped any material or liquid such as water onto the monitor when cleaning, unplug the power cable immediately and contact your dealer or the nearest service center. Always make sure your hands are dry when unplugging the power cable.
CAUTION
∙For safety reasons,
∙Do not scratch or rub the screen with a hard object.
∙Never use any of the following solvents on the LCD Monitor. Such harsh chemicals may cause damage to the cabinet and the sensor:
Thinner
CABINET
∙Remove dirt with a lightly moistened cloth and a mild solvent detergent. Then wipe the cabinet with a soft dry cloth.
DISPLAY AREA (SENSOR)
∙Periodic cleaning with a soft dry cloth is recommended.
∙Do not use tissue to clean the display area. It may scratch or dull the LCD screen.
Page 9