Table of Contents | Texas Memory Systems RAM-SAN 520 specification

		Table of Contents
Chapter 1 - Overview			1-1
Chapter 2 - Installation			2-1
2.1	Inspection		2-1
2.2	E.S.D. Warning		2-1
2.3	Rack Mounting		2-1
2.4	Connecting to the management port		2-1
2.5	Power-Up		2-2
2.6	System Tests		2-2
2.7	Connecting the Fibre Channel Ports		2-2
Chapter 3 - Understanding Your RAM-SAN			3-1
3.1	Interface Slot Numbering		3-1
3.2	Inside the RAM-SAN		3-1
3.3	Bus Layout		3-1
3.4	Power		3-1
3.5	Configuration Board and LEDs		3-2
3.6	The Front Panel Display		3-3
Chapter 4 – Configuring the RAM-SAN			4-1
4.1 The RAM-SAN Monitor			4-1
4.2	Configuring the Ethernet Port		4-1
4.3	Configuring LUNS		4-1
4.3.1 A Worked Example on Changing the RAM-SAN Configuration			4-2
4.3.2 Resizing LUNs			4-3
4.3.3 Attaching Fibre Channel Ports to the LUNs			4-3
4.3.4 Creating LUN Masks			4-4
4.3.5 Saving the Configuration to Flash RAM			4-5
Chapter 5 – Using the Management Port			5-1
5.1 testmem			5-1
5.2 errchat <on/off>			5-1
5.3 exit (quit)			5-1
5.4 help			5-1
5.5 history			5-2
5.6 ipconfig			5-2
5.7 log			5-2
5.8 partition			5-2
5.9 performance			5-2
5.10 password			5-2
5.11 reboot <hard/soft>			5-2
5.12 reset <port>			5-2
5.13 status [port]			5-3
Chapter 6 - Troubleshooting			6-4
6.1	Basic Items to Check		6-4
6.2	Management Port Fails to Boot		6-4
6.2.1 MCP21 Does Not Display Characters			6-5
6.2.2 Boot Sequence Does Not Complete			6-5
6.2.3 Does Not Accept Character Input			6-5
6.3	RAM-SAN Boots Incorrectly		6-5
6.3.1 RAM-SAN Detects Partial or No Memory			6-5
6.3.2 RAM-SAN Does Not Detect all Devices			6-6
6.3.3 Catastrophic Boot Error Detected			6-6
6.4	Finding Bad Memory		6-6
6.4.1 Locating a Bad Memory Board			6-6
6.4.2 Confirming a Bad Memory Board			6-6
6.5	Confidence Diagnostic, DIAGMEM, Fails		6-7
6.6	A Power Board LED Does not Light or Blinks or Bad Fuse LEDs are Lit		6-7
6.7	Configuration LED Stays Lit		6-7
6.8	ECC Errors Detected		6-8
RAM-SAN User’s Guide		Texas Memory Systems, Inc. (February 7, 2003)	i