04 
Toughpower 750W
ATX 12V 2.2 & EPS 12V Version
2. Components Check
1750W power supply unit
2One AC Input power cord
3Mounting screws
4User manual
Toughpower 750W 
05
ATX 12V 2.2 & EPS 12V Version
3. Installation
3.1 Warnings and Cautions
3.1.1Do not pull the AC power cord when the power supply is in use or else damage to components will result.
3.1.2 Do not store the Power Supply in a high humidity and high temperature environment.
3.1.3When using an ATX type power supply under testing conditions where the power supply unit is not installed in a PC with its components, please follow the steps below: 1)Please take a paper clip and untwist it.
2)Make sure the power supply unit is in the "OFF" position. 3)Locate the 20 or 24 pin motherboard connector from the
power supply unit.
4)Plug one side of the paper clip into the green wire hole. 5)Plug the other side of the paper clip into any of the black
wire holes.
6)Turn on the PSU to see if the power supply fans turn on.
3.1.4High voltages exist in the power supply. Do not open the power supply case unless you are an authorized service technician or electrician.
3.1.5All warrantees and guarantees shall be voided should there be a failure to comply with any of the warnings and cautions covered in this manual.
Build for the Extreme-
Build for the Extreme-