Tote Vision LCD-1700VRQ manual Vertical & Horizontal Position Adjustment

Page 14

________________________17” Quad display LCD monitor

OSD V-position

Change the OSD Vertical Display location in the screen

Move to the next OSD screen

Move to the previous OSD screen

OSD transparency setting

To set the OSD display transparency mode.

Load default

OSD time out timer setting

VERTICAL & HORIZONTAL POSITION ADJUSTMENT

1.

Use the & Δ key to move the 3to the

ICON, then

 

press

& + to move the whole screen left or right to the

 

center position.

 

2.

Use the & Δ key to move the 3to the

ICON, then

 

press

& + to move the whole screen down or up to the

 

center position.

 

ADJUST THE VIEWING SCREEN SIZE

 

1.

Use the & Δ key to move the 3to the

icon , then

 

press

& + to get the larger viewing size.

2.

Use the & Δ key to move the 3to the

icon ,then

 

press the & + key to get the stable setting.

12

Image 14
Contents Page Page Introduction Before Installing Your MonitorRGB Mode About Your MonitorFACTORY-PRESET Modes Specifications Vesa DDC 1/2BEMI Installing the Monit or Product PackageFollow These Steps to Install the Monitor Control Functions Adjusting the PC Monitor Adjustment ProcedureAuto Adjustment H-POSITION OSD SCREEN1OSD SCREEN2 255Adjustment Icon Vertical & Horizontal Position Adjustment Brightness Adjustment Understand the Display Resolution Setting Adjusting the Security Screen Setting Adjustment ProcedureTime Setup Menu System Camera Alarm Playback VersionSystem Setup Format YY-MM-DD Date DwellAlarm Setup Audible OFF/ON CH1 CH2 CH3 CH4 PB OUT PWR PWPage RGB Signal Connector Appendix