SOYO SY-6ZB quick start Configure Memory, Set SW1 for power up FSB clock and AGP bus clock

Hardware Installation

SY-6ZBQuick Start Guide

Step 3. Configure Memory

Your board comes with two DIMM sockets, providing support for up to 256MB of main memory using DIMM modules from 8MB to 128MB. For 66MHz front side bus CPUs use 12ns or faster memory; for 100MHz front side bus CPUs use 8ns (100MHz, PC100 compliant) memory.

Memory Configuration Table

Number of Memory Modules	DIMM 1		DIMM 2
1	1st
2	1st		2nd
RAM Type		SDRAM
Memory Module Size (MB)	8/16/32/64/128 Mbytes

Important: It is of prime importance that you install DIMM modules as outlined in the table above in order to preserve signal integrity on 100MHz front side bus systems.

Step 4. Set SW1 for power up FSB clock and AGP bus clock.

SW1 is used to adjust AGP bus clock frequency depending on the value of the front side bus (FSB) clock, also the setting of the SW1 determines the power up FSB clock which will remain effective until the BIOS set the FSB clock to the CMOS setting.

SW1 Setting	Power up FSB Clock	AGP Clock
	66MHz	AGP Clock
		= FSB Clock ÷ 1
	100MHz	AGP Clock
		= FSB Clock ÷ 1.5

Note: The specification of maximum AGP bus Clock frequency is 66.6MHz.

∗Set SW1 to open when you use a FSB 100MHz CPU.

∗Set SW1 to close when you use a FSB 66MHz CPU.

∗Set SW1 to open when you use a FSB 66MHz CPU but want to over clock the FSB clock to 100MHz via the BIOS setting.

8